Male SAE Inverted Flare Swivel x Push-on Hose Barb

Male SAE Inverted Flare Swivel x Push-on Hose Barb

Part Number 2900610C
Material Brass
Component Material Yellow Plastic Cap
Male Thread UNF
Male Thread Size 5/8"-18
Tube OD 3/8"
Hose ID 3/8"
Hex 5/8"
Length 1.78"
Pressure Rating 350 PSI
Temperature Range -40 to +150°F
Weight Lb 0.0700


  • Number of Barbs: 2
  • Barb Length:.92"


  • Assembly Instructions:
  • 1. Trim hose end with smooth square cut.
  • 2. Lubricate either push-on fitting, hose or both.
  • 3. Insert push-on fitting into hose until first barb is in hose.
  • 4. Place end of fitting against a flat object (bench, wall, etc.) and grip the hose one inch from end. Push with a steady force until end of hose is covered by yellow plastic cap.


  • Disassembly instructions:
  • 1. Leaving push-on fitting in place, make a 1" cut in the hose along the barbed end of the fitting. Note: Be careful not to nick barbs when cutting the hose.
  • 2. With firm grip on hose, give a sharp downward pull to release the fitting from the hose.


  • No hose clamps or ferrules are needed

Safety notes

  • Dixon push-on fittings are intended for use with Lok-On (push-on style) hose only.
  • Caution: Push-on fittings will properly grip push-on hose only when pushed all the way in, with the cut end of the hose completely concealed by the plastic cap.
  • WARNING: Cancer and Reproductive Harm-



Catalog Page

Interactive Resources


Related Products


Stock Availability